- Autres entreprises Fluke:
- Fluke
- Fluke Biomedical
- Fluke Networks
- Fluke Process Instruments
Design and Evaluation of Pressure Balances for the Boltzmann Constant Project
In support of the project for determination of the Boltzmann constant by dielectric constant gas thermometry a system of pressure balances has been designed and constructed with the goal of defining pressures in helium in gauge and absolute measurement modes up to 7 MPa with a relative standard uncertainty of 1∙10-6. The design supports this reduced uncertainty with focus on the areas of temperature stability, mass uncertainty, effective area and pressure distortion coefficient. The system includes two pressure balance platforms, three 20 cm2 and three 2 cm2 piston-cylinder assemblies (PCAs) and automated mass handlers. The design of the PCAs and of their mounting was optimized to reduce pressure distortion coefficients and mounting induced deformations. The PCAs gap width was adjusted to reach an optimal compromise of fall rate and sensitivity. In order to perform automated cross-floats with the pressure balances with a possibility of different gases and a high level of cross-float sensitivity, differential pressure cells (DPCs) were applied to indicate pressure equilibrium. The pressure balances have similar performance with both nitrogen and helium. For any pair of the PCAs, comparisons conducted by automated cross-floats demonstrate repeatability of area ratios within (0.2 to 0.5)∙10-6 up to 7 MPa. The effective area ratios obtained from cross-floats for all possible combinations of PCAs are consistent within 0.96∙10-6. Using dimensional measurements, the effective area of the 20 cm2 and 2 cm2 PCAs were determined with relative standard uncertainties of 0.7∙10-6 and 1∙10-6, respectively. Based on the currently available dimensional and cross-float data the relative standard uncertainty of the absolute pressure of 7 MPa is equal to 2.1∙10-6.
- Accueil
- Produits
- Nouveautés
- Étalonnage électrique
- Étalonnage RF
- Équipements de test et d'acquisition de données
- Étalonnage de la température
- Étalonnage d'humidité
- Étalonnage de pression
- Manomètres à piston
- Contrôleurs/Étalonneurs
- Moniteurs de pression
- Balances manométriques
- Étalonneurs et moniteurs manuels
- Handheld Pressure Calibrators
- Étalonnage de données d'air
- Moniteurs environnementaux
- Accessoires d'étalonnage de pression
- Systèmes d'étalonnage de pression personnalisés
- Logiciel d'étalonnage de pression
- Étalonnage de débit
- Outils d'étalonnage de process
- Logiciel d'étalonnage
- Service et assistance
- Tous les instruments d'étalonnage
- Instruments de mesure portables
- Où acheter
- Actualités
- Formation
- Littérature et de l'éducation
- Service et Support
- Service Request (RMA)
- Programmes d'assistance
- Assistance technique
- Base de connaissances
- Accréditations
- Centres de service agréés
- Calibration Certificates
- Community Forum
- My MET/SUPPORT
- Manuels des produits (manuels d'utilisation)
- Fiches de données de sécurité (FDS)
- Programme de recyclage
- Safety, Service, and Product Notices
- Garantie
- Téléchargements de logiciels
- Qui nous sommes