- Autres entreprises Fluke:
- Fluke
- Fluke Biomedical
- Fluke Networks
- Fluke Process Instruments
A Comparison between a Resistance Bridge and an Integrated-Circuit Resistance Thermometer Readout Used for SPRT Calibration
Specially designed bridges are used for standard platinum resistance thermometer (SPRT) calibration to achieve lowest uncertainty. Such bridges are expensive and their measuring speeds are slow. A new type of instrument reported a few years ago was compared against the bridge to see if it is possible to use the new instrument instead of the bridge for SPRT calibration in some cases. Four SPRTs were calibrated at the triple point of water and the freezing points of tin and zinc using a Model 6010T Bridge and the new instrument (Model 1590) simultaneously. At these calibration points the maximum differences between the two instruments were within 0.4 mK at the tin point, and within 0.7 mK at the zinc point. The maximum difference in resistance ratio W(t) at these points was within 0.9 ppm of the readings. The differences over the entire range from 0°C to 419.527°C were calculated for the four SPRTs. The maximum differences were within 0.1 mK close to 0°C, within 0.5 mK at 300°C and within 0.7 mK at 420°C. The comparison results show the new instrument can be used for SPRT calibration to achieve an expanded uncertainty (k=2) as low as 1.5 mK.
- Accueil
- Produits
- Nouveautés
- Étalonnage électrique
- Étalonnage RF
- Équipements de test et d'acquisition de données
- Étalonnage de la température
- Étalonnage d'humidité
- Étalonnage de pression
- Manomètres à piston
- Contrôleurs/Étalonneurs
- Moniteurs de pression
- Balances manométriques
- Étalonneurs et moniteurs manuels
- Handheld Pressure Calibrators
- Étalonnage de données d'air
- Moniteurs environnementaux
- Accessoires d'étalonnage de pression
- Systèmes d'étalonnage de pression personnalisés
- Logiciel d'étalonnage de pression
- Étalonnage de débit
- Outils d'étalonnage de process
- Logiciel d'étalonnage
- Service et assistance
- Tous les instruments d'étalonnage
- Instruments de mesure portables
- Où acheter
- Actualités
- Formation
- Littérature et de l'éducation
- Service et Support
- Service Request (RMA)
- Programmes d'assistance
- Assistance technique
- Base de connaissances
- Accréditations
- Centres de service agréés
- Calibration Certificates
- Community Forum
- My MET/SUPPORT
- Manuels des produits (manuels d'utilisation)
- Fiches de données de sécurité (FDS)
- Programme de recyclage
- Safety, Service, and Product Notices
- Garantie
- Téléchargements de logiciels
- Qui nous sommes