- Autres entreprises Fluke:
- Fluke
- Fluke Biomedical
- Fluke Networks
- Fluke Process Instruments
Improvement Study on the Use of Dry-Well Calibrators for PRT Calibration
Radial and axial temperature gradients in the block and instability and hysteresis of the control sensor are main deficiencies that affect the performance of dry-well (block) calibrators. These inherent limitations are inevitable in a dry-well calibrator with single-zone control. In order to reduce calibration errors and improve the performance of dry-well calibrators, a new dry-well calibrator with dual-zone control, called “Metrology Well Calibrator,” was developed at Fluke- Hart Scientific. The performance of the new dual-zone dry-well calibrator was evaluated.
The axial temperature uniformity was measured using a specially made platinum resistance ther-mometer. The special PRT has a very short sensor within a platinum capsule, but no sheath. It is an excellent probe for measuring vertical temperature uniformity. The design of this PRT will be described briefly.
Several PRTs with different structures were calibrated at fixed points and then tested in the dual-zone Metrology Well Calibrator to identify measurement errors. The results will be reported.
- Accueil
- Produits
- Nouveautés
- Étalonnage électrique
- Étalonnage RF
- Équipements de test et d'acquisition de données
- Étalonnage de la température
- Étalonnage d'humidité
- Étalonnage de pression
- Manomètres à piston
- Contrôleurs/Étalonneurs
- Moniteurs de pression
- Balances manométriques
- Étalonneurs et moniteurs manuels
- Handheld Pressure Calibrators
- Étalonnage de données d'air
- Moniteurs environnementaux
- Accessoires d'étalonnage de pression
- Systèmes d'étalonnage de pression personnalisés
- Logiciel d'étalonnage de pression
- Étalonnage de débit
- Outils d'étalonnage de process
- Logiciel d'étalonnage
- Service et assistance
- Tous les instruments d'étalonnage
- Instruments de mesure portables
- Où acheter
- Actualités
- Formation
- Littérature et de l'éducation
- Service et Support
- Service Request (RMA)
- Programmes d'assistance
- Assistance technique
- Base de connaissances
- Accréditations
- Centres de service agréés
- Calibration Certificates
- Community Forum
- My MET/SUPPORT
- Manuels des produits (manuels d'utilisation)
- Fiches de données de sécurité (FDS)
- Programme de recyclage
- Safety, Service, and Product Notices
- Garantie
- Téléchargements de logiciels
- Qui nous sommes